Pay attention to the standard steps when replacing the industrial synchronous belt

When replacing these products with pulleys, the power should be turned off in advance, the protective cover should be removed, and the mounting bolts of the motor should be loosened. Move the motor so that the Timing Belt is sufficiently slack to remove the drive belt without prying it off. Never pry the belt off. Remove the old drive belt and check for abnormal wear. Excessive wear may indicate a problem with the design or maintenance of the transmission,

Needless to say, choose a suitable Synchronous Belt to replace. To clean the transmission belt and the transmission pulley, you should wipe the rag with a little non-volatile liquid. Dirt, rubbing it with sandpaper or scraping it with a sharp object is obviously not advisable. Belts must be kept dry before installation and use.

The next step is to check: Check the timing pulley for cracks or wear, preferably with a professional measuring tool. If the wear is excessive, the pulley must be replaced. Check that the drive pulley is symmetrical in line. Check the remaining transmission components such as bearings and bushings for symmetry, durability and lubrication. For multi-belt drives, all belts must be replaced, if only one old belt is replaced on a multi-belt drive, the new belt may be properly tensioned, but all the old belts will be under tension and the drive It may be loaded by this new belt alone, causing the new belt to fail prematurely.